Interface Command

Interface Command

R1 Configuration:                                                          |   R4 Configuration:
From Global configuration mode:                                   From Global configuration mode:
R1(config)#interface s2/0                                              |   R4(config)#interface s2/0
R1(config-if)#ip address 12.0.0.1 255.255.255.0          |   R4(config-if)#ip address 34.0.0.4 255.255.255.0
R1(config-if)#clock rate 64000                                      |   R4(config-if)#clock rate 64000
R1(config-if)#no shutdown                                             |   R4(config-if)#no shutdown
R1(config-if)#interface loopback 0                                 |   R4(config-if)#interface loopback 0
R1(config-if)#ip address 11.11.11.11 255.255.255.0     |   R4(config-if)#ip address 44.44.44.44 255.255.255.0
R1(config-if)#end                                                           |   R4(config-if)#end
R1#copy running-config startup-config                           |   R4#copy running-config startup-config
R1#show ip interface brief                                              |   R4#show ip interface brief
Note: * Check Ip adress configure to Interfaces, Status and Protocol should be up.
--------------------------------------------------------------------------------------------------------------------------------
R2 Configuration:                                                           |   R3 Configuration:
From Global configuration mode:                                   |   From Global configuration mode:
R2(config)#interface s2/0                                               |   R3(config)#interface s2/0
R2(config-if)#ip address 12.0.0.2 255.255.255.0          |   R3(config-if)#ip address 34.0.0.3 255.255.255.0
R2(config-if)#clock rate 64000                                      |   R3(config-if)#clock rate 64000
R2(config-if)#no shutdown                                             |   R3(config-if)#no shutdown
R2(config-if)#interface fa0/0                                           |    R3(config-if)#interface fa0/0
R2(config-if)#ip address 23.0.0.2 255.255.255.0           |   R3(config-if)#ip address 23.0.0.3 255.255.255.0
R2(config-if)#no shutdown                                             |   R3(config-if)#no shutdown
R2(config-if)#interface loopback 0                                 |   R3(config-if)#interface loopback 0
R2(config-if)#ip address 22.22.22.22 255.255.255.0                               |   R3(config-if)#ip address 33.33.33.33 255.255.255.0
R2(config-if)#end                                                          |   R3(config-if)#end
R2#show ip interface brief                                             |   R3#show ip interface brief

Note: * Check Ip adress configure to Interfaces, Status and Protocol should be up.